Sa 200 remote installation on short hood with a r51

[86montano]

Hello does anyone know how to install a remote on a short hood with a bellows ideler

[guajilloweld03]

Read this post to get you going:

https://weldingweb.com/vbb/showthrea...ighlight=short

[86montano]

Yes but my machine has a the r51 bellows idler
And is wired a bit different there’s two wire that come out the casing and go to the bellows then to the reostate and none of the diagrams I see make sense

[KC51]

There is a document here that compiles many of the SA200 manuals: http://www.billswelderrepair.com/fil...00_manuals.pdf
Wiring diagrams are near the end. Look at pages 200-205 for short hood.
Note that the link to this manual in the SA200 sticky no longer works

[86montano]

Thx for the info what is the difference between series exiter and compound exiter