anybody use one of these. Rose indes

[tapwelder]

https://www.lakeshorecarbide.com/rose-index.aspx

[M J D]

https://www.lakeshorecarbide.com/rose-index.aspx

Looks very useful but a lot of money for what it is. I usually use a shaft collar with a flat machined opposite the setscrew. I then use one of the small digital angle finders

[tapwelder]

Yeah. I borrowed similar idea from somebody on this site. Perhaps you?

The tool.seems useful. Especially with the hex and octagonal option. The vid show it being used to locate and drill 6 even spaced holes in round stock.

Not something I need, but could put it use.

It would be pretty fast option.

[M J D]

Yeah. I borrowed similar idea from somebody on this site. Perhaps you?

The tool.seems useful. Especially with the hex and octagonal option. The vid show it being used to locate and drill 6 even spaced holes in round stock.

Not something I need, but could put it use.

It would be pretty fast option.

It would be fast. A lot of times a 5c collet block is all I need . A lot of money for a seldom used tool, unless there's other uses I'm not seeing right now.

[M J D]

MrPragmaticLee on youtube just posted a video about making the larger 2" version.

[Steve_12]

MrPragmaticLee on youtube just posted a video about making the larger 2" version.

It has a very high quality picture, great combination of video!