Results 1 to 2 of 2

Thread: Miller Big 40 / SA-200 parts

  1. #1
    Join Date
    Mar 2018
    Posts
    74
    Post Thanks / Like

    Miller Big 40 / SA-200 parts

    I have a Miller Big 40 that threw a rod through the block not too long after rebuild. Lots of good parts left that maybe someone could use. This machine uses F163 engine, so engine parts could go to either another Big 40 or SA-200. Off the top of my head:

    Carburetor (Zenith) - rebuilt within last few hundred hours
    Distributor - bought new within last few hundred hours
    Head - machined at rebuild - less than 50 hours
    Governor - original

    Fine control rheostat -Less than 1 year old
    Range selector - original but working at time of engine failure
    Fuel tank - cleaned and lined less than 2 years ago
    Vacuum idle setup - was working at time of engine failure

    Any other parts someone might need aside from block and maybe crank???

    Any interest? Let me know and we can talk price. If not, I'll scrap machine out in the next few weeks

  2. #2
    Join Date
    Jul 2012
    Posts
    819
    Post Thanks / Like

    Re: Miller Big 40 / SA-200 parts

    Well that's not good about throwing a rod. Those old continentals are pretty tough, too bad it cannot be saved.

    http://www.locknstitch.com/cast-iron-welding.html

    Maybe you could try this on your block.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Page generated in 1,619,125,129.75001 seconds with 12 queries