Results 1 to 5 of 5

Thread: MIG/TIG Welding EMI Source -- Medical device

  1. #1
    Join Date
    Apr 2021
    Location
    Wisconsin
    Posts
    3
    Post Thanks / Like

    MIG/TIG Welding EMI Source -- Medical device

    Hello All,
    Have a question that I was curious about. I have a medical device and am able to weld on lower currents (below 180 amps) without any problems. I noticed that the manual for my welder said for people sensitive to EMI to stay away from the power source. What is the power source? In an MIG/TIG welder is most of the EMI coming from the arc itself (i.e. where we're melting metal) or the machine?

    Thanks

  2. #2
    Join Date
    Jun 2012
    Location
    CT
    Posts
    4,277
    Post Thanks / Like

    Re: MIG/TIG Welding EMI Source -- Medical device

    At least for DC welding I bet an inverter creates more EMI than the arc due to the frequencies used in the switching circuits. I run a ham radio here pretty frequently and I get most of my interference from my daughters' LED light strings hanging in their bedrooms

  3. Likes sargent11235 liked this post
  4. #3
    Join Date
    Jun 2017
    Location
    AJO, ARIZONA
    Posts
    3,807
    Post Thanks / Like

    Re: MIG/TIG Welding EMI Source -- Medical device

    I know a guy that was told not to weld after recieving a pacemaker, I don't know if this helps with your question. but that's what I know.
    IMPEACH BIDEN!
    NRA LIFE MEMBER

    UNITWELD 175 AMP 3 IN1 DC
    MIDSTATES 300 AMP AC MACHINE
    GOD HELP AMERICA!
    “Freedom is never more than one generation away from extinction.
    We didn’t pass it to our children in the bloodstream".
    RONALD REAGAN

  5. #4
    Join Date
    Sep 2016
    Location
    Detroit, Michigan
    Posts
    870
    Post Thanks / Like

    Re: MIG/TIG Welding EMI Source -- Medical device

    From a literal perspective, the power source should be either the transformer or inverter in the welder. The torch/stinger/etc is where the power is applied, not the source. If they were considering the source to be the torch there is no way to stay away from it. On the flip side, with a longer torch setup you can stay away from the power source and still weld.
    Check out my bench vise website:
    http://mivise.com


    Miller Syncrowave 250DX
    Millermatic 350P with XR AlumaPro
    Miller Regency 200 with 22A feeder and Spoolmatic 3
    Hobart Champion Elite
    Everlast PowerTig 210EXT

  6. Likes sargent11235 liked this post
  7. #5
    Join Date
    Sep 2020
    Posts
    16
    Post Thanks / Like

    Re: MIG/TIG Welding EMI Source -- Medical device

    A welder with an implanted pacemaker must use special insulating gloves, not work in a humid environment, and avoid working with currents exceeding 400 A. The ground terminal should be attached to the welding electrode as close to the welding spot as possible.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Page generated in 1,623,728,331.94086 seconds with 12 queries