Instructions, or Settings For an Import Plasma Cutter

[SweetMK]

I think I searched pretty good,, but, I can not find any help,,
I set up my 50A plasma cutter from Amazon,,

(I bought a TOOLIOM Plasma Cutter TL-50C )

The manual that is included is not much,,

Anyways, is there anywhere I could find suggested settings for a plasma cutter,

So far, what I have learned,,
I think there is different tips for 115 versus 220 volt operation.
I set the air pressure according to what I found in the manual ("between 5 and 6")

I think that is too much air, it blows out the arc.
I turned the air pressure down to "4",, and the arc stays on.

Today I was cutting some metal roofing, much heavier gauge than typical roofing,,
With the amps at 15 (it goes up to 50) and the air at "4",, the cutter was amazing.
It was literally able to cut faster than I could move the torch.

I was afraid I would burn up the torch running such low air pressure. Hmmmmmmmmmm,,

Does anyone have any helpful settings hints, or a place to go to find a "better" instruction manual?

Thanks !!

[albrightree]

Here's my Lotos Cut 50 manual. Page 27 has amps and pressure to thickness settings.

HTH

[Broccoli1]

Here's my Lotos Cut 50 manual. Page 27 has amps and pressure to thickness settings.

HTH

No manual in yer post

[shovelon]

Here's my Lotos Cut 50 manual. Page 27 has amps and pressure to thickness settings.

HTH

Which makes me think. Why would a machine manufacturer not include a setup chart with amps, air pressures, and speeds?

[albrightree]

No manual in yer post

OOPS ! Usually I only do that at work, forgot the attachment. The OP hasn't noticed yet.

https://store-n37vtomhd0.mybigcommer...l/LTP5500D.pdf

https://www.weldingweb.com/images/smilies/laughing.gif

Looked at the Tooliom website, and if sends you to the amazon page, where at the bottom before the reviews are the start up and run settings, and directions: https://www.amazon.com/TOOLIOM-Non-T...ef_=ast_sto_dp

[SweetMK]

This must be a pretty new machine,,
none of that info was on the Amazon website on March 30 2021 when I ordered the machine,

Thanks for the info,, and the links,,