Results 1 to 3 of 3

Thread: Troubleshooting.

  1. #1
    Join Date
    Jun 2021
    Posts
    2
    Post Thanks / Like

    Troubleshooting.

    Good afternoon gentleman, I'm having issue with a the definition of a code on a Lincoln Powerwave s350. The error code is 279. I can't seem to find what
    the definition is, the operator's manual does not show it. Can someone help please. Thanks.

  2. #2
    Join Date
    Mar 2010
    Location
    Ceres, California
    Posts
    3,884
    Post Thanks / Like

    Re: Troubleshooting.

    If you have the powerwave manager program you can look it up there.
    If not, go to powerwavesoftware.com and down load it. with it and an ethernet cable you can look at the fault logs. Take a snap shot and send it to Lincoln for then to look at.
    Gives several problems that can cause it. depends on when it shows up.
    Check all the dip switches and make sure the welder and the feeder are in the same group. Feeder in group 1 and welder in group 2 will cause this fault.
    See owner's manual on dip switch settings.

  3. #3
    Join Date
    Jun 2021
    Posts
    2
    Post Thanks / Like

    Re: Troubleshooting.

    Quote Originally Posted by ccawgc View Post
    If you have the powerwave manager program you can look it up there.
    If not, go to powerwavesoftware.com and down load it. with it and an ethernet cable you can look at the fault logs. Take a snap shot and send it to Lincoln for then to look at.
    Gives several problems that can cause it. depends on when it shows up.
    Check all the dip switches and make sure the welder and the feeder are in the same group. Feeder in group 1 and welder in group 2 will cause this fault.
    See owner's manual on dip switch settings.



    You are a gentleman and a scholar sir. Thank you.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Page generated in 1,632,582,836.50232 seconds with 13 queries