Powcon 550 to single phase

[R2Gonzo]

Hi, I am trying to convert the 550 Powcon to single phase. I changed the tabs from 460 to 230. The plug is where I'm confused. I hooked it up without the red wire
Turns on, fan turns on but not sure of it's correct. Anyone have any suggestions.

Thank you,
Ruben

[ArcPowTech]

Hi Ruben,

If it turns on and fan is running, then it sounds like you've got it right. Are you having other issues with it?


Best regards,
Mike

[R2Gonzo]

By Yes, it runs. I got the 550 manual and it gave single-phase instructions. I used 3 wires green white and black. Then isolated the red per the manual. Now just trying to hook up the power drive 1 to it. The point doesn't match up. I need to get a diagram for the power drive. Any suggestions.

Thank you
Ruben

[ArcPowTech]

Hi Ruben,

The Mirabel website is finally up and running. You can download the Operation Manual for the Power Drive I here: mirabeliwe.com/downloads. You can see the schematic including the remote pin-out toward the end on page 4-25. Let me know if you have any questions.


Best regards,
Mike

[R2Gonzo]

Thank you again Mike. This is a great resource. I appreciate it
Ruben