Results 1 to 3 of 3

Thread: PowCon 14 pin connectors

  1. #1
    Join Date
    Sep 2021
    Posts
    3
    Post Thanks / Like

    PowCon 14 pin connectors

    Hi all,

    I have a PowCon 400SMT with a PD20 feeder, both with 17 pin Amphenol (lettered) connectors. My foot pedal has a 14 pin AMP (numbered) connector, connected via a 17 pin to 14 pin pigtail adapter. Been happily MIG, TIG, and stick welding with this setup for 25 years.

    I just picked up an RC250P pulser unit, but it has 14 pin Amphenol (lettered) connectors.

    Does anyone have a pin out diagram for the 14 pin Amphenol lettered connectors used on the PowCon machines?

    Thanks,
    Scott

  2. #2
    Join Date
    Oct 2014
    Posts
    1,282
    Post Thanks / Like

    Re: PowCon 14 pin connectors

    Last edited by danielplace; 09-20-2021 at 11:03 PM.

  3. #3
    Join Date
    Sep 2021
    Posts
    3
    Post Thanks / Like

    Re: PowCon 14 pin connectors

    Thanks for the reply. Definitely some good information and very similar to my foot pedal setup.

    This pulser seems a bit different as it has the lettered connector pins. I was kind of hoping someone might have a copy of a PowCon RC250P manual with a schematic or connector diagram.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Page generated in 1,638,348,707.83548 seconds with 11 queries