PowCon 14 pin connectors

[scottro_pro]

Hi all,

I have a PowCon 400SMT with a PD20 feeder, both with 17 pin Amphenol (lettered) connectors. My foot pedal has a 14 pin AMP (numbered) connector, connected via a 17 pin to 14 pin pigtail adapter. Been happily MIG, TIG, and stick welding with this setup for 25 years.

I just picked up an RC250P pulser unit, but it has 14 pin Amphenol (lettered) connectors.

Does anyone have a pin out diagram for the 14 pin Amphenol lettered connectors used on the PowCon machines?

Thanks,
Scott

[danielplace]

Check this thread,

https://www.practicalmachinist.com/v...wiring-305492/

[scottro_pro]

Thanks for the reply. Definitely some good information and very similar to my foot pedal setup.

This pulser seems a bit different as it has the lettered connector pins. I was kind of hoping someone might have a copy of a PowCon RC250P manual with a schematic or connector diagram.