Results 1 to 4 of 4

Thread: Pro Cut 55 Problem

  1. #1
    Join Date
    Nov 2021
    Location
    Louisiana
    Posts
    4
    Post Thanks / Like

    Pro Cut 55 Problem

    I have a Procut 55, its been performing well for years. However it is not after turning on and fans start up. All lights light up for a few seconds then start flashing. I press the trigger on the torch and noting happens. Can't get the light to go out. I installed new Lincoln consumables and still the same.

    Any know what's going on?

    Thanks

  2. #2
    Join Date
    Mar 2010
    Location
    Ceres, California
    Posts
    3,968
    Post Thanks / Like

    Re: Pro Cut 55 Problem

    Are all the lights on the display panel flashing or just one?
    All lights flashing is a pcb failure. one light depends on which light?.
    Try the trouble shooting guide in the owner's manual.
    Place a call to Lincoln tech support and see what they say.

  3. #3
    Join Date
    Oct 2014
    Posts
    3,854
    Post Thanks / Like

    Re: Pro Cut 55 Problem

    You probably already know to make sure the nozzle and gun are tightened up fully. I had a Pro Cut 55 years ago. I liked it but it went through consumables fairly fast. I think it was one of the first not to use high frequency arc starting.

  4. #4
    Join Date
    Mar 2015
    Posts
    257
    Post Thanks / Like

    Re: Pro Cut 55 Problem

    I have a pro cut 40 does same thing sent it in no parts available

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Page generated in 1,642,502,943.97683 seconds with 13 queries