Amico MIG-130A

[Chiefcook]

Does anyone have any firsthand info on this machine? Good or bad.

[doxie]

I have amco mig-200 for year or so, nice welder ~~no problems, worth every penny!
Bob Fillmore NY

[smithdoor]

Looks good the one I look at had 120/240 volt.
Note I would only use 0.030" [0.8mm] wire size on small welders.

Dave

Does anyone have any firsthand info on this machine? Good or bad.

[smithdoor]

You can come by 240 volts from your dryer plug.

Dave

Does anyone have any firsthand info on this machine? Good or bad.

[California]

I bought one in December. I like it.

Here's a thread I posted on WeldingSite. My recent post shows a test of welding then bending 1/8" material. It did a nice job. The welds were solid after bending the material 90 degrees.

[smithdoor]

Nice review 👌

I wish I could see the schematic.

Dave

I bought one in December. I like it.

Here's a thread I posted on WeldingSite. My recent post shows a test of welding then bending 1/8" material. It did a nice job. The welds were solid after bending the material 90 degrees.