Connector name

[psacustomcreations]

This two wire connector goes to my TIG Button controller.
Late yesterday I pulled the wires out so need to replace it or fix it.
What is this type of connector called so I can look for a new one.
The company is not open yet and I can call later, but if I can find the name I can order the part myself.

Thanks



Sent from my SM-G996U using Tapatalk

[duramax-rob]

i don't know the connector name but usually there is a tab that is suppose to stick up from the metal end facing the wires and prevents the wires from pulling out. pry this tab up and reinsert.

[smithdoor]

Stress relief if is for electrical.
The photos did not show up until posted
That is a plug used in electronics some are custom by company. I save the parts and hope it works. The barb can be found in bags try a computer repair to buy a hand full of size you need.

Dave

i don't know the connector name but usually there is a tab that is suppose to stick up from the metal end facing the wires and prevents the wires from pulling out. pry this tab up and reinsert.

[smithdoor]

FYI the plug part is not need but barb can be plugged in with out the the plastic plug.

Dave

This two wire connector goes to my TIG Button controller.
Late yesterday I pulled the wires out so need to replace it or fix it.
What is this type of connector called so I can look for a new one.
The company is not open yet and I can call later, but if I can find the name I can order the part myself.

Thanks



Sent from my SM-G996U using Tapatalk

[bigb]

Looks like a Molex connector to me, with a locking tab

[danielplace]

That was a tough one to locate.

These are what they are using I believe.

6 months to get them. Lol. Lets go Brandon.

https://www.digikey.com/en/products/...3957-2/1152435

I would solder them in cleanly and heat shrink them and call it done.

[psacustomcreations]

That was a tough one to locate.

These are what they are using I believe.

6 months to get them. Lol. Lets go Brandon.

https://www.digikey.com/en/products/...3957-2/1152435

I would solder them in cleanly and heat shrink them and call it done.

That looks just like it. Many thanks.
I reached out the manufacturer of the Tig Button and am trying to get them from him.

The problem is in trying to plug this end back into the control box.

[danielplace]

That looks just like it. Many thanks.
I reached out the manufacturer of the Tig Button and am trying to get them from him.

The problem is in trying to plug this end back into the control box.

Oh yes I see. We don't wanna be soldering on there.