TIG question - Hobart Multi Handler 200

[McDaniel8402]

Howdy! I just bought a new Hobart Multi Handler 200 because I wanted one unit to run stick and TIG with. I'm accustomed to my old Miller DialArc HF, and a little Miller MaxStar as well. I'm wanting fingertip controls for TIG for my new machine, but I'm concerned that it may not be available. There seems to be little to no information out there. Anybody have any firsthand experience with setting up fingertip controls on this Hobart unit? I don't care if the parts are aftermarket. I just want something that will work.

[Munkul]

It has a foot pedal input so presumably you just need the wiring pin-out, and then you can set up a hand amptrol.

[albrightree]

American Torch Tip makes a simple switch that you can tie wrap to your TIG torch for on / off operation.

I don't know if SSC controls company is making a "Touch 4 TIG Welding Remote Fingertip Torch Hand Control" for the Hobart. It might be the same pinout as the Miller units. Is it a 14 pin circular connector ?

[CAVEMANN]

Welcome to welding web!

[NotaVegetarian]

Welcome to the board, I would like to test one of those machines out. Please tell us how you like it

[smithdoor]

Welcome to the group

Dave

Howdy! I just bought a new Hobart Multi Handler 200 because I wanted one unit to run stick and TIG with. I'm accustomed to my old Miller DialArc HF, and a little Miller MaxStar as well. I'm wanting fingertip controls for TIG for my new machine, but I'm concerned that it may not be available. There seems to be little to no information out there. Anybody have any firsthand experience with setting up fingertip controls on this Hobart unit? I don't care if the parts are aftermarket. I just want something that will work.

[Broccoli1]

Howdy! I just bought a new Hobart Multi Handler 200 because I wanted one unit to run stick and TIG with. I'm accustomed to my old Miller DialArc HF, and a little Miller MaxStar as well. I'm wanting fingertip controls for TIG for my new machine, but I'm concerned that it may not be available. There seems to be little to no information out there. Anybody have any firsthand experience with setting up fingertip controls on this Hobart unit? I don't care if the parts are aftermarket. I just want something that will work.

Hobart is pretty good with customer service- were they not helpful?

You can also post on their forum- Hobart Expert kieth usually checks in

https://weldtalk.hobartwelders.com