Results 1 to 2 of 2

Thread: Lincwelder 225 running issues

  1. #1
    Join Date
    Jun 2022
    Posts
    1
    Post Thanks / Like

    Lincwelder 225 running issues

    Hey Iím new here and am in need of some knowledge on my lincwelder 225. Started having problems with it staying running. I thought there must be a filter under the housing between the sediment bowl and gas tank. But after further disassembly thatís not the case. I by passed everything and just hooked up a fuel line to a gas can. It ran perfect. So I bet bypassed the sediment bowl and again it wont run steady. Misses,pops, and cuts out when any load is applied. Please lend me your knowledge

  2. #2
    Join Date
    May 2008
    Location
    Orange, TX
    Posts
    17,552
    Post Thanks / Like

    Re: Lincwelder 225 running issues

    Could be looking at a bad fuel pump as in dried out/cracked diaphragm.

    Check for gas in the crankcase that would be a definite indication of a bad fuel pump diaphragm.
    MM200 w/Spoolmatic 1
    Syncrowave 180SD
    Bobcat 225G Plus - LP/NG
    MUTT Suitcase Wirefeeder
    WC-1S/Spoolmatic 1
    HF-251D-1
    PakMaster 100XL
    '68 Red Face Code #6633 project
    Star Jet 21-110

    Save Second Base!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Page generated in 1,660,281,275.92620 seconds with 12 queries